External water feature getting lekage problem when we did proper waterproof?
Water feature flowing fall down from the 1meter height from concrete base and when we did proper water proof later we did stone cladding. If it is small gap also we did close with marble grouting with silicon, finallly we are not able to control water lekage.
So, kindly give solution to close lekage problem.
Best answer:
Answer by meanolmaw
how much leak is there?..... is your water level going down more than an inch?.... ...with a three ft tall waterfall, you're losing some water to wind and spray.... but if it's more than the inch, due to spray and evaporation, then you should look to your pump, filter, hoses and connections.....
Add your own answer in the comments!
Faux Rock Foaming Water Fountain-bubbling feature-patio-deck-garden-landscape | US $67.50 (0 Bid) End Date: Thursday May-17-2012 16:51:03 PDT Bid now | Add to watch list |
 | US $128.95 (0 Bid) End Date: Thursday May-17-2012 16:51:05 PDT Bid now | Add to watch list |
Related posts:
- Q&A: How can i make a low humidity water feature for my leopard gecko tank?
- Anyone know how to make a water feature out of a douche bag?
- How To Choose A Water Feature
- Q&A: How do you drill a hole in a rock for a water feature?
- What is the best way to remove a water feature from a yard?
Sounds like the waterproofing was not fully effective or was damaged after you applied it. Did it leak before the marble cladding? Possible that the installation of the marble punctured the liner or whatever water proofing you used. Silicon is an effective water seal. Marble could transfer water past the edge of the caulk (grout is a sand based mortar). Consider a stone or concrete seal product over the marble if you are willing to accept its appearance. Otherwise you may need to remove the marble, use an elastomer type product to seal the feature, and then reinstall the marble over the top.